Products

About Us

Knowledge Center

Accessories

Terms of Use

Featured Products

Site Map

Videos

Contact Us

Motorized Z-axis Table

Home >  Assorted Motorized Multi-axis Stages >  Motorized Z-axis Linear Positioning Stages

Motorized Single-axis Vertical Stage, Travel  : 15 mm

This motorized positioning table is made of aluminum alloy with an elegant black anodized surface.

It provides 15 mm of travel at a Maximum Speed with Stepper Motor of 5 mm per second. The drive mechanism is lead screw.

The bench size is 65 X 65 mm and has a body weight of 1.2 Kg.

The maximum load of this stage table is 10 Kg.

This linear stage is also available with a three phase brushless motor and  Optical Encoder .

The knob mounted on the motor allows for manual adjustment. This knob may be replaced with an  Optical Encoder  for precision position verification.

This stage requires a Motion Controller that can be ordered as a complete plug-and-play system with RS-232, USB, joystick, trackball, and keypad control.

Specifications
Type

Z110-15

Structure Description

Travel

15 mm

Table Size 65 mm 65 mm
Lead Screw Pitch 1 mm per turn
Travel Guide

High Precision Crossed Roller

DB-9 Male Connector

 

Two-Phase Stepper Motor
Typical Phase Resistance 3.8 Ohms, Bi-directional
Typical Phase Current 1 Amp
 
Pin Assignment and Description
1 +5 VDC for the Limit Sensors
2

CCW Limit Switch
The table moves away from the motor
The knob turns counter clockwise
Open Collector
Normally Open
Needs Pull up Resistor (typically 1000 Ohms)

3

CW Limit Switch
The table moves towards the motor
The knob turns clockwise
Open Collector
Normally Open
Needs Pull up Resistor (typically 1000 Ohms)

4 Return for+5 VDC
5 Not Connected
6 Stepper Motor Phase A+
7 Stepper Motor Phase A-
8 Stepper Motor Phase B+
9 Stepper Motor Phase B-
Body Material Aluminum Alloy
Surface Treatment Black Anodized
Load capacity 5 kg
Weight 1.2 kg

Typical Accuracy

Resolution Control Electronics Dependent, 0.5 microns with 10 Micro-steps per Step Motor Driver in use
0.25 microns with 20 Micro-steps per Step Motor Driver in use
Maximum Speed with Stepper Motor 5 mm / sec
Maximum Speed with Servo Motor  
Positioning Accuracy 10 microns

Accessories Description

Positioning Repeatability

+/- 2 microns
 Optical Encoder
Three Phase Brushless Servo Motor and  Optical Encoder (-02 Version)


Stepper Motor Driven Mechanical Drawing

Stepper Motor Driven Single-axis Vertical Stage, Travel: 15 mm

Click to Get the STEP file

 Ordering Information

Part No. Description Amount
Z110-15-01 Stepper Motor Driven Single-axis Vertical Stage, Travel  : 15 mm Click to Get a Quote
Z110-15-02 Three Phase Brushless Servo Motor with Quadrature Incremental  Optical Encoder Driven Vertical Stage, Travel  : 15 mm Click to Get a Quote
Z110-15-03 DC Servo Motor with Quadrature Incremental  Optical Encoder  Driven Vertical Single-axis Stage, Travel  : 15 mm Click to Get a Quote
Z110-15-04 Stepper Motor Driven Single-axis Vertical Stage with 500 Cycles per Revolution Quadrature Optical Encoder Mounted at the back of the Stepper Motor, Travel  : 15 mm Click to Get a Quote

OES line of Motion Controllers Motion Controllers
Sharing link:


 

Home | Products | Accessories | Knowledge Center | About Us | Terms of Use |Testimonials | Featured Products |Site Map | Videos | Contact Us